Mercedes of the S-class W202

1993-2000 of release

Repair and operation of the car


Mercedes W202
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Lubrication system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. System of ignition
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
- 14. Electric equipment
   14.1.2. Measuring devices
   14.1.3. Technology of measurements
   14.1.4. Checks of electric equipment
   14.1.5. Sound signal
   14.1.6. Replacements of safety locks
   + 14.1.7. Rechargeable battery
   + 14.1.8. Generator
   + 14.1.9. Starter
   14.1.10. Traction relay
   + 14.1.11. System of lighting
   14.1.12. Devices
   14.1.13. Dashboard
   14.1.14. Glow lamps on the dashboard
   14.1.15. Light switch
   14.1.16. Radio receiver
   - 14.1.17. Antenna
      14.1.17.1. Telescope of the automatic antenna
   14.1.18. Loudspeakers
   + 14.1.19. Rubber brushes of screen wipers
   14.1.20. Windscreen washer jets
   14.1.21. The washing nozzles of headlights
   14.1.22. Screen wiper and its engine
   14.1.23. Protect the car
   14.1.24. Anticreeping "immunodeficiency"
   14.1.25. Why headlights grow dull
   14.1.26. Galogenka
+ 14.2. Electrical circuitries





14.1.17. Antenna
GENERAL INFORMATION

77, 78. Bolts

79. Top part of consolidation

80. Lower part of consolidation

81. High-frequency wire

82. Electric socket

M11. Automatic antenna

Removal

PERFORMANCE ORDER
1. Disconnect a weight(s) wire from the plug of the rechargeable battery.
Prevention

At the same time the anticreeping code of radio is erased. Before a detachment of wires see recommendations of subsection 14.1.7.

2. Open a trunk lid, release spring clips and Take a side covering.
3. Unscrew a wire for connection with the case together with a bolt (77).
4. Unscrew the antenna below on the holder (78) and Take it from below from the rubber plug in a wing. Disconnect from plugs an antenna wire (81) and if is available, the line of management (82).

Installation

PERFORMANCE ORDER
1. Check the rubber plug in a wing for lack of porosity or damage, if necessary replace it.
2. Enter the antenna from below and insert its spherical head into the lower part of the plug.
3. Spread the top part of the plug and record it in the lower part.
4. Screw the antenna on the holder.
5. Screw on a body a wire for connection of the antenna with the car case.
6. Attach an antenna wire to the plug. In the presence of the antenna with remote control connect the electric line of management to the plug.
7. Get and fix by spring clips a side covering.
8. Attach a weight(s) wire to the plug of the rechargeable battery. Determine time on hours and program an anticreeping code for radio.